Before use, you will need to fit the battery to the monolight. Each monolight has a
groove within the battery compartment for the corresponding lug on the battery.
The battery is held in place by the clip activated by the
button as shown at left.
Slide the battery lugs into the slots on the monolight as
shown in the pictures below.
Swivel the battery on the lugs until it clicks firmly in
place.
Please remove the batteries from the monolights for transport.
As the batteries have a finite life and a finite number of recharge cycles we don’t want
to be charging them needlessly so if the charge indicator is showing two or more lights
don’t worry about charging them. One light or less, please recharge them.
This may take a number of hours depending on the level of charge.
Anecdotally, you should get nearly 400 full power shots from a fully
charged battery!
Page 15 of 26
To Next Page
