If you have any further queries please contact
our customer service team on 0121 328 7507
or email at ‘contact@jllfitness.co.uk’
IC300 MONITOR INSTRUCTIONS
If your monitor is not displaying any readings some things to check are;
1. The wires connected during assembly are securely clipped together
2. The pins at the end of the wires are not bent in any way
*Please not the distance will only measure in miles and not kilometers*
The monitor will
automatically be in ‘SCAN’
mode
To exit ‘SCAN’ mode press
the single button on the
monitor, continuously press
the button until the arrow
aligns with your chosen
setting
To reset the monitor press
and hold the single button
until all of the zero’s flash
1. SET UP
2. BASICS
3. TROUBLESHOOT
W hen inserting the batteries
make sure they are the
correct way round
To Next Page
Need help?
General
