If you have any further queries please contact
our customer service team on 0121 328 7507
or email at ‘contact@jllfitness.co.uk’
R200 MONITOR INSTRUCTIONS
If your monitor is not displaying any readings some things to check are;
1. The wires behind the monitor are connected
2. The sensor underneath the slideway is attached securely
W hen replacing the
batteries make sure they
are the correct way round
Remove the black tape to
replace the batteries
To remove the monitor
push up the small clip
at the bottom
The monitor will
automatically be in ‘SCAN’
mode
Press the single button on
the monitor to exit ‘SCAN’
mode, continuously press until
the arrow corresponds to the
correct setting
Press and hold the single
button to reset the
monitor back to zero
1. SET UP
2. BASICS
3. TROUBLESHOOT
To Next Page
Need help?
General
