Need help?Do you have a question about the JML exakt EC310-AS and is the answer not in the manual?
Keep work area clean and lit, avoid explosive atmospheres, and keep bystanders away.
Match plugs to outlets, avoid grounded surfaces, protect from rain/moisture, and handle cords with care.
Stay alert, use safety equipment, avoid accidental starts, remove keys, maintain balance, and dress properly.
Use correct tool, ensure switch works, disconnect power for adjustments, store properly, maintain tool, and keep cutting edges sharp.
Have power tools serviced by qualified personnel using identical replacement parts.
Keep hands clear of blade, secure workpiece, hold tool by insulated surfaces, use rip fence, and use correct blades.
Understand kickback, maintain grip, release trigger when binding, support panels, use sharp blades, caution with plunge cuts.
Check guard closing, return spring, guide plate, and ensure it covers blade when not in use.
Keep handles dry, avoid lateral force on blade, store tools properly, replace defective parts, use RCD outdoors, use recommended accessories.
Ensure dust hose is connected and attached to a vacuum cleaner or dust extractor.
Adjust depth using the control knob and scale. Set slightly greater than material thickness for best results.
Unplug tool, lock shaft, remove cover, unscrew retaining screw, and depress guard to remove/replace blade.
Unplug tool, unscrew guard release screw, and slide guard off. Never use without the guard.
Clamping is optional but recommended for inexperienced users or small/tough materials.
The saw cuts up to 12mm deep. Thicker material can be cut from both sides.
Proper grip ensures easier and safer operation. Instructions provided for right and left-handed users.
Use plunge action, cut forward only, use sharp blades, set depth, switch on, plunge gently, feed slowly, keep base plate flat.
Use guard pointers or a metal ruler to follow cutting lines accurately.
Use guard indication marks to align with start/finish lines for precise cut-outs.
Overlap corners for waste removal if covered. Finish visible corners with a knife or cut from the back.
Practice with wood first. Use more force for tough materials. Avoid toxic dust/fumes.
Set depth 1mm greater, use scrap material, remove burrs, apply beeswax, allow tool to rest. Do not cut galvanized steel.
Use specific blades, employ dust extraction, and apply tape to prevent scratching.
Use for occasional cut-outs with dust extraction. Conventional tools may be better.
The tool produces dust; use forced dust extraction for efficient cleaning and safety.
Connect hose to nozzle with metal clip. Ensure guard moves freely. Use adaptor for vacuum hose.
The tool has a safety feature that stops operation if it overheats, requiring cooldown.
The V Guard is for cutting pipes/dowels. Use specific blades and support the workpiece.
Regular cleaning is crucial for safe operation. Clean dust nozzle and ensure no build-up.
This consumable washer prevents damage if the blade jams. Replace if worn or damaged.
Always use sharp blades. Blunt blades cause poor performance and overheating. Blades are consumable.
Contact EXAKT Precision Tools for servicing and official replacement parts.
To Next Page
General