Using Your Vac Pack Go!
Safety Warnings & Advice
Using Your Vac Pack Go! Using Your Vac Pack Go!
1. Prepare the clothes:
Put the clothes into vacuum bag and seal.
2. Sealing the bag:
Hold the sealing strips together and slide the sealing clip along
them.
3. Connect compressor to the vacuum bag:
Remove the twist cap
from the valve and then
place the compressor
over the valve, making sure
to keep the base flat to
maintain the best contact.
4. Connect power cable:
Connect the USB cable to a
power supply and then to
the compressor.
Note: This unit is not chargeable
and will need to be connected to
a power source.
5. Turning it on:
Simply press the button on the top to activate the compressor.
6. Turning it off:
Simply press the button on top
to turn off the compressor once
the desired compression has
been achieved. Remove the
compressor from the valve and
then screw the cap back on to
ensure the bag is fully sealed
Note: Operational time may vary
depending on the contents and desired
amount you wish to compress the bag.
This can range from approximately 2-10
minute.
The Vac Pack Go! Compressor is not a toy.
Keep out of reach of children.
Choking hazard. Product contains small parts.
WARNING: Avoid danger of suffocation. Keep
storage bags away from babies & children.
Not suitable for feather pillows and duvets.
DO NOT place food or liquid in the bags.
DO NOT use the bags to store any leather
goods or fine clothing.
DO NOT place objects with feathers in the bags
In order to avoid damaging the pump, please
ensure that all contents are completely dry
before using.
DO NOT overfill the bags. This could damage
the zipper and the bag.
DO NOT bend the zipper as it may not seal if it
is damaged.
Use a damp cloth to wipe clean and air dry.
To Previous Page
Loading...