CERTIFICATIONS
FCC ID: 2AQK5-BEAMO1
IC ID: 24113-BEAMO1
FCC and IC
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and (2) this device must ac
-
cept any interference received, including interference that may cause undesired
operation.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an un
-
controlled environment. End users must follow the specic operating instructions
for satisfying RF exposure compliance. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
IC Statements:
This device complies with Industry Canada licence-exempt RSS standard(s). Op
-
eration is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using
an antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent isotropically radiated pow
-
er (e.i.r.p.) is not more than that necessary for successful communication.
To Next Page
Loading...
Need help?
General
