Joerns Healthcare UltraCare XT User Manual (English)

Questions and Answers:

B
Brian SmithAug 2, 2025
What to do if Joerns Healthcare Medical Equipment bed not responding to pendant control?
- B
  barnesadamAug 2, 2025
  If your Joerns Healthcare medical equipment bed isn't responding to the pendant control, here are a few things to try: * First, check the lockout status. * Make sure the connection is fully inserted and the cable is secure. * Verify that the bed is plugged into a power source and that the control box green light is on. * As a last resort, unplug the bed for 60 seconds, then plug it back in.
A
Anthony MclaughlinAug 8, 2025
What to do if Joerns Healthcare Medical Equipment bed not responding to staff control?
- D
  Deborah FrancisAug 8, 2025
  If your Joerns Healthcare medical equipment bed isn't responding to the staff control, here are a few things to try: * First, check the lockout status. * Make sure the connection is fully inserted and the cable is secure. * Verify that the bed is plugged into a power source and that the control box green light is on. * As a last resort, unplug the bed for 60 seconds, then plug it back in.
H
Heather FerrellAug 14, 2025
What to do if all lockout indicators are flashing on Joerns Healthcare Medical Equipment?
- K
  karen82Aug 14, 2025
  If all lockout indicators are flashing on your Joerns Healthcare medical equipment bed, try these steps: 1. Unplug the bed for 60 seconds and then plug it back in. 2. If that doesn't work, push and hold the Hi-Lo up and down buttons on the staff control or pendant simultaneously until the flashing stops. This should take no more than 15 seconds.
J
Jamie LeAug 21, 2025
Why is Hi-Lo lockout indicator flashing on Joerns Healthcare Medical Equipment?
- K
  kcoleAug 21, 2025
  If the Hi-Lo lockout indicator is flashing on your Joerns Healthcare medical equipment bed, it indicates a thermal overload condition. This should correct itself in 2 minutes or less. Ensure that you do not surpass a 10% duty cycle (2 minutes on / 18 minutes off).
E
eandersonAug 27, 2025
What to do if Knee Lockout indicator flashes when attempting articulation on Joerns Healthcare UltraCare XT?
- M
  Melanie ValdezAug 27, 2025
  If the Knee Lockout indicator flashes when attempting articulation on your Joerns Healthcare medical equipment bed, it could be due to a couple of reasons. First, the bed may be in a reverse Trendelenburg or comfort chair position; in that case, level the bed. Another possible solution is to lower or raise the Hi-Lo to the end of its travel.

Joerns Healthcare UltraCare XT Specifications

General

Product Type	Hospital Bed
Power Source	Electric
Width	35 inches
Length	80 inches
Features	side rails
Mattress Type	Not included, requires separate purchase
Power Requirements	110-120 VAC
Therapy Modes	Trendelenburg and Reverse Trendelenburg
Control Type	Hand pendant