To Next PageTo Next Page
Need help?Do you have a question about the Jogler JLT-6000 series and is the answer not in the manual?
General| Brand | Jogler |
|---|---|
| Model | JLT-6000 series |
| Category | Transmitter |
| Language | English |
Explains the magnetostrictive principle of operation using a float's magnetic field and a waveguide.
Specifies ambient and process temperature limits for transmitter electronics and waveguide probe.
Details the maximum process pressure rating for the LGT-6000 series waveguide probe.
Outlines the required 24 VDC nominal power supply and warnings against incorrect voltage.
Specific mounting instructions for MGT series using L brackets and pipe clamps.
Steps for attaching the ILT thermowell assembly and inserting the waveguide probe.
Instructions for attaching the LGT transmitter head, sensor, and waveguide.
Details how to access the terminal block and connect wiring using shielded twisted pair cable.
Describes using the keypad buttons to navigate menus and calibrate the transmitter.
Details default display options: level, percentage, loop output, or error messages.
Guides setting 0% and 100% points based on float position for calibration.
Determines current loop output during a fault condition (Low, High, Latch).
States transmitters are designed for low maintenance and outlines periodic inspection requirements.
Lists performance characteristics: accuracy, repeatability, linearity, rate of change, and damping.
Details electrical input, output, resistance, power consumption, error signal, and interface.
Provides process pressure, ambient temperature, and process temperature ratings for models.
