MEGADYNE™ Smoke Evacuator
Optimized Device Performance Guide
Before you begin
1. Plug in power cord: Insert power
plug into the receptacle on the
MEGADYNE™ Smoke Evacuator.
2. Recommended: Plug in connect
cable. Insert the male connector of
the connect cable into the
receptacle on the MEGADYNE™
Smoke Evacuator and the female
connector into the receptacle on the
electrosurgical generator.
3. Alternate: Connect RF sensor to monopolar cord. When connecting smoke
evacuator and electrosurgical generator via connect cable is not possible:
a. Insert RF sensor (sold separately)
into the RF sensor port on
MEGADYNE™ Smoke Evacuator.
b. Insert monopolar pencil cord or
return electrode cord into the
receptacle on RF sensor.
Generator
Smoke
evacuator
Connect
cable
To Next Page
Need help?
General