Johnson Controls CK721-A - Restoring the Controllers Configuration Settings

Software Version 3.3 Factory Field Upgrade
24-10025-113 Rev. –
18
RESTORING THE CONTROLLER’S CONFIGURATION SETTINGS
Use Tera Term Pro to configure the upgraded CK721-A controllers for
operation. You must configure each controller before connecting it to the
Johnson Controls Security Management System (SMS). When preparing a
CK721-A controllers for operation, you must:
• Enter the IP address of the CK721-A
• Enter the netmask of the CK721-A
• Enter the IP address of the P2000 server
• Configure the Download Port number, the Upload Port number, and the
Priority Port number to match those defined at the P2000 Server. The
default values are:
Once the IP addresses are assigned at the controller, they cannot be
changed from the P2000 software.
• Modify the network polling rate, if needed
• Modify the route information, if needed
• Modify the network polling delay, if needed
Once each controller has been configured for operation, reconnect each
controller to the P2000 host. For details on preparing a CK721-A controller for
operation and connecting to the host, refer to the CK721-A Network Controller
Installation and Operation Manual.
Port Type Port Number
Download Port 41014
Upload Port Number 41013
Priority Port Number 41012