Always review and follow the directions provided in your foam
kit. The below instructions are a general overview, meant to
Accompany the reference photos. Ensure you follow all safety
Precautions including wearing protective eyewear and gloves.
• Tear open the back of the box (Figure 20).
• Without forcing, remove hoses and applicator to full length
(Figure 21).
• Ensure gun safety is on (roller is locked toward end of
applicator).
• Pull yellow tab to remove black plastic valve lock. Discard.
(Figure 22)
• Activate valves by pulling black strap up and insert strap
into slit (marked in yellow) on back of box. Hoses will
partially ll with chemicals.
• Hold unit upside down, move roller to “on” position
(Towards hoses), and dispense foam. Adjust roller to
increase/decrease ow.
• If dispensing is stopped for more than 30 seconds, replace
nozzle with the extra provided.
• Foam can be trimmed, painted, sanded or plastered after
curing completely.
To Next Page
Loading...
