QUANTUM™ HD COMPRESSOR CONTROL PANEL
COMMUNICATIONS SETUP
090.040-CS (JAN 14)
Page 101
SECTION 7
WARNING/SHUTDOWN MESSAGE CODES
The following list represents all of the current warning/shut-
down messages that are potentially displayable (at the time of
this writing). The numeric value to the left of each message
corresponds to the value that is read from the Safety Mes-
sage addresses (Frick
®
address 3070 – 3079). As an example, if
Frick
®
address 3070 were being read, and it returned a value of
51, then referring to the chart on the following pages, it would
be found that the code of 51 represents Oil Level Shutdown.
3 Balance Piston 1 Shutdown
4 Balance Piston 2 Shutdown
5 Balance Piston 3 Shutdown
6 Liquid Slugging Warning
7 Liquid Slugging Shutdown
8 High Oil Filter Pressure Warning
9 High Oil Filter Pressure Shutdown
10 Missing Comp. Oil Pressure Warning
11 Missing Comp. Oil Pressure Shutdown A
12 Missing Comp. Oil Pressure Shutdown B
13 Insufficient Main Oil Pressure Shutdown
14 High Motor Current Shutdown
15 High Motor Current Warning
16 Low Motor Current Shutdown
17 High Discharge Temperature Sensor Fault
18 High Discharge Temperature Shutdown
19 High Discharge Temperature Warning
20 High Suction Pressure Shutdown
21 High Suction Pressure Warning
22 Low Separator Temperature Shutdown
23 Low Separator Temperature Warning
24 High Comp. Oil Temperature Shutdown
25 High Comp. Oil Temperature Warning
26 Low Comp. Oil Temperature Shutdown
27 Low Comp. Oil Temperature Warning
28 Low Suction Shutdown - Regulation Mode 1
29 Low Suction Warning - Regulation Mode 1
30 Low Suction Shutdown - Regulation Mode 2
31 Low Suction Warning - Regulation Mode 2
32 Low Suction Shutdown - Regulation Mode 3
33 Low Suction Warning - Regulation Mode 3
34 Low Suction Shutdown - Regulation Mode 4
35 Low Suction Warning - Regulation Mode 4
36 Regulation Mode 1 Shutdown
37 Regulation Mode 1 Warning
38 Regulation Mode 2 Shutdown
39 Regulation Mode 2 Warning
40 Regulation Mode 3 Shutdown
41 Regulation Mode 3 Warning
42 Regulation Mode 4 Shutdown
43 Regulation Mode 4 Warning
44 Low RPM Shutdown
45 Low RPM Warning
46 High RPM Shutdown
47 High RPM Warning
48 High Manifold Pressure Shutdown
49 High Manifold Pressure Warning
50 Low Main Oil Injection Pressure Shutdown
51 Oil Level Shutdown
52 Compressor Capacity Unload Alarm
53 False Running Fail -- Motor Amps
54 False Running Fail -- Confirmed Running Inp
55 High Limit Disch Pres Shutdown
56 High Limit Disch Temp Shutdown
57 High Disch Pres Shutdown -- Mode 1
58 High Disch Pres Warning -- Mode 1
59 High Disch Pres Shutdown -- Mode 2
60 High Disch Pres Warning -- Mode 2
61 Start Failure Shutdown For Eng And Turb
62 High Liquid Level Shutdown
63 Auxiliary Input 1 Shutdown
64 Auxiliary Input 1 Warning
65 Auxiliary Input 2 Shutdown
66 Auxiliary Input 2 Warning
67 Auxiliary Input 3 Shutdown
68 Auxiliary Input 3 Warning
69 Auxiliary Input 4 Shutdown
70 Auxiliary Input 4 Warning
71 Auxiliary Input 5 Shutdown
72 Auxiliary Input 5 Warning
73 Auxiliary Input 6 Shutdown
To Next Page
Loading...
