QUANTUM™ HD COMPRESSOR CONTROL PANEL
COMMUNICATIONS SETUP
090.040-CS (JAN 14)
Page 116
For easy reference, the DIP switch position functions are
provided on the board. For the purpose of clarity however,
refer to the following table:
MODULE DIP SWITCH SETTINGS
Switch
Position
ON Function OFF Function
1 RS-485 RS-422
2 RS-422 RS-485
3 RS-422 RS-485
4 RS-422 Pull up No pull up
5 RS-485 Pull up No pull up
6 RS-422 Pull down No pull down
7 RS-485 Pull down No pull down
8 RS-485 termination No termination
MOUNTING THE MODULE
This module can be mounted on the standard din rail that
is available in most control panels.
• Find an open area of the din rail (5/8 inch minimum,
for the width of the module), and preferably as far
away from any inductive loads (relays, contactors,
etc.) as possible.
• Module orientation is not critical, however, try to
mount it so that all wiring connections can be made
neatly, and according to any applicable local codes.
• Catch one end of the DIN rail latch (at the bottom of
the module, under one edge of the DIN rail, then snap
the other latch onto the opposite side of the DIN rail,
as shown below:
Module mounted to DIN rail
WIRING THE MODULE
There are twelve total wire terminal points on this mod-
ule. Refer to the following table for the pin-out:
Wire terminal connections
Terminal
Position
Module
Power
RS-232 RS-422 RS-485
1 -RX
2 +RX
3 (Not Used)
4 -TX -RX/-TX
5 +TX +RX/+TX
6 (Not Used)
7 -24 VDC
8 (Not Used)
9 +24 VDC
10 GND
11 TX
12 RX
• Locate a suitable source for the +24 volt DC
power. Using a minimum of 18 AWG stranded
wire, connect the MINUS wire to terminal # 7.
Connect the PLUS wire to terminal # 8.
• All remaining connections will be based upon
the particular protocols that you have decided
to use. Simply match the SIGNAL NAME from the
source device to match the SIGANAL NAME of
the module. All external communications wiring
must conform with the Frick
®
Proper Installation
of Electronic Equipment in an Industrial Environ-
ment publication.
Refer to the following figure for the pin connections
showing how to wire the Converter Module for RS-232:
RS-232 Wiring To Frick
®
Communications Converter Mod-
ule
To Next Page
Loading...
