QUANTUM™ HD COMPRESSOR CONTROL PANEL
COMMUNICATIONS SETUP
090.040-CS (JAN 14)
Page 38
MESSAGE READ SETUP SCREEN
The following setup screen is programmed to obtain 28
consecutive data files from the Quantum™ HD (ID#1)
N10:1 register and place them into the SLC500’s N10:1
through N10:28 register. The target address must be
changed to for the Quantum™ HD.
• This Controller: SLC500
• Data Table Address: Data file location in the SLC500
• Size in Elements: # of data file to read
• Channel: Port location on the SLC processor (Channel
0 is the RS-232 port)
• Target Device: Quantum™ Panel
• Data Table Address: Data file location in the Quan-
tum™ HD controller.
• Local Node: Quantum™ HD ID# (Octal)
To Next Page
Loading...
