Johnson Controls HICM008B21S - Function Setting Details; Sensor Installation Position and Louver Control Settings

SM-18003
5-33
EXTERNAL INPUT/OUTPUT AND FUNCTION SETTING
(94) Not Prepared (L2)
(95) Louver Setting during Energy-Saving Forced Thermo-OFF (L3)
(96) Fan Speed during Energy-Saving Forced Thermo-OFF (L4)
Thisfunctionisutilizedtoincreasethefanspeedtopreventthedeteriorationofcomfortduetoforce
thermo-OFFforenergysavingduringcoolingoperation.
SettingCondition AirVolumeDuringForceThermo-OFF
AirFlowVolume HIGH2 HIGH MED LOW
00(Standard) HIGH2 HIGH MED LOW
01(HiSpeed) HIGH2 HIGH2 HIGH MED
SettingCondition Energy-SavingForceThermo-OFF
00(ReceiveAir:LOW) LouverstayindownwardairowpositionduringAutoSwingMode
01(ReceiveAir:MED) Louverstayindownwardairowpositionlongerthan"00"duringAutoSwingMode
02(ReceiveAir:HIGH) Louverisxedatthe7thstepofdownwardairow
03(NotAvailable) Cancelthelouveroperation
(93) Motion Sensor Installation Position (L1)
Thisfunctionisutilizedtoselecttheinstallationpositionofthecoverforcornerwithmotionsensorand
radiationtemperaturesensorbywiredcontroller.
SettingCondition Installation Position
00 A(Factory-Setting)
01 B
02 -(NotAvailable)
03 D
Ref.
Pipe
Mark of
Mark of
Mark of
Mark of
Mark of
The motion sensor cannot
install to the location of the mark of “C” .
B
C
A
The mark of “A” is
the factory setting position
for motion sensor.
D
Electrical Box
Decorative Panel without
Four Corner Covers
(97) Louver Swing Operation during Energy-Saving Forced Thermo-OFF (L5)
Thisfunctionissetat"01",thefunction"L3"settingwillbeavailable.
(98) Not Prepared (L6)
(99) Not Prepared (L7)
(100) Not Prepared (L8)
(101) Not Prepared (L9)
(102) Not Prepared (LA)
(103) Not Prepared (Lb)
(104) Setting Temperature (P1)
Thisfunctionisutilizedtoprovidesettingtemperatureforevery1
o
F (0.5
o
C)at"00"andevery2
o
F (1
o
C)
at"01".
Controldifferentialofthermistoralsousesthetemperatureforevery1
o
F (0.5
o
C)at"00"andevery2
o
F
(1
o
C)at"01".
(105) Not Prepared (P2)
(106) Thermistor Selection (P3)
Thisfunctionisutilizedtoselectthethermistorwithfunction(107).
SettingCondition Thermistor(Sensor)
00 InletAirThermistor
01 OutletAirThermistor
02 ThermistorofRemoteControl
03 RemoteSensor