Setting left or right door orientation
Complete the following steps to ensure the lock functions correctly after you install it.
Before you begin: Ensure the hole in the door frame is drilled to a minimum of 1 in. / 25 mm
deep.
1. With the thumb turn in the vertical unlocked position, insert 4 AA batteries.
2. If the latch bolt does not start as part of auto-orientation, use a sharp pointed tool to press
and hold the reset button for 5 seconds until you hear a long beeping sound.
3. If the reset is successful, the latch bolt extends.
4. Replace the battery cover.
19IQ Lock-PowerG Installation and User Guide D-309240
To Next Page
Loading...