JOHNSON CONTROLS
10
FORM 145.05-FA1
ISSUE DATE: 10/31/2019
SECTION 1 - SMALL CABINET FIELD ASSEMBLY
Use pipe clamp to
align the two sections
at the base.
LD14775
FIGURE 9 - ALIGN BASES
Pressure
Seal Door
LD15020
FIGURE 10 - OPEN PRESSURE SEAL DOOR
12. Remove the condenser access panel as indicated
in Figure 11
13. Enter the reconnect area of the fan section to per-
form the next step (Figure 12).
14. From Table 1 on page 7, use Item 1, the 3/8-
inch -16 x 1-1/4 inch bolt; Item 3, the 3/8-inch
lock washer; and Item 4, the 3/8-inch at washer
to connect the fan and coil sections together as
directed in Steps 15, 16, and 17.
Condenser Access
Panel
LD15017
FIGURE 11 - REMOVE COMPRESSOR ACCESS
PANEL
Reconnect area
of fan section.
LD14778
FIGURE 12 - ENTER THE RECONNECT AREA
To Next Page
Loading...
