Johnson Controls LSWU - FIGURE 25 - Align Bases; FIGURE 26 - Open Pressure Seal Door; FIGURE 27 - Remove Condenser Access Panel; FIGURE 28 - Enter the Reconnect Area

JOHNSON CONTROLS
16
FORM 145.05-FA1
ISSUE DATE: 10/31/2019
SECTION 2 - MEDIUM CABINET FIELD REASSEMBLY
11. Use a pipe clamp to align the two sections at
the base. In most cases, this helps align the pre-
punched holes in the coil section with the nut in-
serts in the fan section (Figure 25).
12. Access the lower reconnect area by opening the
pressure seal door on the fan section (Figure 26).
Use pipe clamp to
align the two sections
at the base.
LD14775
FIGURE 25 - ALIGN BASES
Pressure
Seal Door
LD14978
FIGURE 26 - OPEN PRESSURE SEAL DOOR
13. Remove the condenser access panel as indicated in
Figure 27.
14. After removing the condenser access panel, enter
the reconnect area of the fan section to perform
the next step (Figure 28).
15. From Table 3 on page 13, use Item 1, the 3/8-
inch -16 x 1-1/4 inch bolt; Item 3, the 3/8-inch
lock washer; and Item 4, the 3/8-inch at washer
to connect the fan and coil sections together as
directed in Steps 15, 16, and 17.
Condenser Access
Panel
LD14981
FIGURE 27 - REMOVE CONDENSER ACCESS
PANEL
Reconnect area
of fan section.
LD14778
FIGURE 28 - ENTER THE RECONNECT AREA