Operating manual- SAB 355 (including ATEX)
54/63
004059 en 2019.11
Maintenance instructions
EU
designation
Reference
model
RWF II
Compressor
model
Discharge flange to
separator flange
Suction flange
Bolt size
Torque
(ft-lb)
Bolt size
Torque
(ft-lb)
SAB 355 S 496 SGC 3511 M24 x 3.0 240 M30 x 3.5 350
SAB 355 L 676 SGC 3515 M24 x 3.0 240 M30 x 3.5 350
SAB 355 E 856 SGC 3519 M24 x 3.0 240 M30 x 3.5 350
SAB 355 X 1080 SGC 3524 M24 x 3.0 240 M30 x 3.5 350
Table 14: Torque requirements
Note: * Based on:
a. Gaskets-Garlock® Blue-Gard® 3300
b. Bolts-class 8.8 or stronger hex head bolts, lightly oiled and clean.
8.3 Monitoring of operation
To ensure satisfactory operation, it is required that you enter certain routines in a logbook on a
regular basis. You can use the items listed in the Start-up log, which is page 2 of the Checklist il-
lustrated in Fig. 24. The service engineer will need this information in connection with, for exam-
ple, error reports.
In addition to the items listed in the start-up log, all other activities of service, maintenance or re-
pair work must be entered into your logbook as required by EN 378 and national laws.
Checklist
Along with this Operating manual we have provided a Checklist, as shown in Fig. 24, which will
serve as a help to the service engineer and must be filled in during commissioning and
start-up.
Keep the filled-in checklist, and send a copy to SABROE Factory as documentation that the unit
has been installed and commissioned correctly. The checklist will be required in case of a warranty
issue.
To Next Page
Loading...
