Operating manual- SAB 355 (including ATEX)
8/63
004059 en 2019.11
Introduction to operating manual
1.1 Compressor name, SABROE/Frick
The compressor in a SABROE SAB 355 screw compressor unit is manufactured by Frick. Below is
indicated how the SABROE and Frick compressor names are made up and how they correspond to
each other.
SABROE name Frick name
SAB 355 S SGC 3511
SAB 355 L SGC 3515
SAB 355 E
SGC/SGX 3519
SAB 355 X
SGC/SGX 3524
Table 1: Compressor overview
1.2 Amendments to the manual
2019.11 Version 2
• Added information about motorised oil injection valve in the ‘Initial start-up procedure’
section.
• Updated general piping diagram.
• New compressor name plates.
• The copies of the declarations of conformity (Unit and ATEX) are now only contained in
the printed manual delivered with the unit and the pdf version uploaded with the order
specific documentation.
• Various minor changes.
2017.12 Version 1
• ATEX information has been added, for example table with temperature classes.
• Name plates with EurAsian Conformity mark (EAC) have been added.
• ‘F-gas regulation’ section has been updated.
• ‘Monitoring of operation’ section has been added, including copy of checklist for commis-
sioning and start-up.
• ‘Requirements for competent persons’ section has been added.
• ‘Noise data’ section has been updated.
• Declarations of conformity, unit and ATEX, have been added.
• And more.
R o t o r d i am e t e r
(first two digits)
Com p r e s s o r
SGC/SGX 3 5 1 9
R o t o r L/D
E
R o t o r d i am e t e r
Com p r e s s o r
SAB 3 5 5
R o t o r length
S h o r t - S
Long - L
Extended - E
Extreme - X
Frick name
SABROE name
H/B
High-pressure/Booster
To Next Page
Loading...
