Engineering manual - UniSAB III 1.10.8
274/346
001930 en 2021.06
UniSAB III (boot) and communication set-up
In the right frame the file content of the software version 1.0.6.5 (in this example) on the SD flash card is
shown.
The path on the flash card to software version 1.0.6.5 must be
X:\UniSABIII\updates\1_0_6_5.
In the Update menu, you have four (five) options:
1. /Transfer - to transfer (configuration) files from UniSAB III to SD card or
/Enter - to transfer software files from SD card to UniSAB III
2. /Position - cursor up
3. /Position - cursor down
4. /Refresh the picture, e.g. if you have inserted another SD card
and are used to navigate up and down in the file list. is used to refresh the file list.
To transfer (download) the configuration files from UniSAB III to the flash card, press /Transfer and
follow the instruction on the screen.
Before inserting the SD card make sure it contains the following path: E:\UniSABIII\updates\1_0_6_5.
Note that the drive letter E:\ and the version number 1_0_6_5 are examples only and may very well be
different from yours.
In this example the path: E:\UniSABIII\updates \1_0_6_5 on the SD card is empty, it does not contain
any files.
Press the /Transfer button to download configuration and setting files from UniSAB III to the flash
card.
To Next Page
Loading...
