Engineering manual - UniSAB III 1.10.8
276/346
001930 en 2021.06
UniSAB III (boot) and communication set-up
The following files are for internal use only. Do not try to open or modify these files as this may crash the
system.
• ShutdownLog.xml - (for internal use only, do not modify)
• TimeLog.xml - (for internal use only, do not modify)
• watchdogLog.log - (for internal use only, do not modify)
• Vfd.dat - (for internal use only, do not modify)
To transfer (upload) the displayed files from the SD flash card to UniSAB III, press and follow the in-
struction on the screen. The following types of files can be uploaded:
• UniSABIII_1065.strip - (program application, not visible in the file overview)
• ResourceBundles – (language file library)
• ResourceBundle - (English language file)
• ResourceBundle_xx - (language file for xx language)
• UniqueConfig.xml - (configuration file, version info, IP setup)
• HMIsettings.xml - (configuration file, favourite’s setup)
• Configuration.xml - (configuration file, configuration setup)
• AnalogInput.xml - (configuration file, analogue limits setup)
• PIDSettings.xml - (configuration file, PID parameter setup)
• Timers.xml - (configuration file, timer setup)
• R000Table.xml - (configuration file, refrigerant R000 setup)
• Modbus.xml - (Modbus TCP address look up file)
The following files are for internal use only. Do not try to open or modify these files as it may crash the
system.
• ShutdownLog.xml - (for internal use only, do not modify)
• TimeLog.xml - (for internal use only, do not modify)
• Vfd.dat - (for internal use only, do not modify)
• Watchdog.log - (for internal use only, do not modify)
• Flashload.sem - (for internal use only, do not modify)
Choose the software version you want to upload, in this case version 1.0.6.5, and press .
To Next Page
Loading...
