Johnson Controls York AYK550 - Communication Parameters

 
$ YORK, A Johnson Controls Company
2_/,2@@23
This group defines set-up variables for a fieldbus adaptor (FBA) communication
module. For more information on these parameters, refer to the user’s manual
supplied with the FBA module. FBAs are modules that plug into the drive.
2_/,2@@23
23 =,2 !7 !2,2 4, #
5101 \J'%   
Displays the type of the connected fieldbus adapter module.
0 = NOT DEFINED – Module not found, or not properly connected, or parameter 9802 is not set to 4 (exT FBA).
1 =
PROFIBUS-DP –
16 =
INTERBUS –
21 =
LONWORKS –
32 =
CANOPEN –
37 =
DEVICENET –
64 =
MODBUS PLUS –
101 =
CONTROLNET –
128 =
ETHERNET –
5102
…
5126
\J%!F\J%!F^ >>>^Q  
For more information on these parameters, refer to the user’s manual supplied with the FBA module.
5127 \J%!!\!# B  
Validates any changed fieldbus parameter settings.
• After refreshing, the value reverts automatically to DONE.
5128 \*"%*\6! \\\\9/  9/
Displays the CPI firmware revision of the drive’s fieldbus adapter configuration file. Format is xyz where:
• x = major revision number
• y = minor revision number
• z = correction number
/@_ 107 = revision 1.07
5129 \*"&\** \\\\9/  9/
Displays the revision of the drive’s fieldbus adapter module’s configuration file identification.
• File configuration information is drive application program-dependent.
5130 \*"&\*! \\\\9/  9/
Contains the revision of the drive’s fieldbus adapter module configuration file.
/@_ 1 = revision 1
5131 \J#''# ^  
Contains the status of the adapter module.
0 =
IDLE – Adapter not configured.
1 =
EXEC. INIT – Adapter is initializing.
2 =
TIME OUT – A timeout has occurred in the communication between the adapter and the drive.
3 =
CONFIG ERROR – Adapter configuration error.
• The major or minor revision code of the adapter’s CPI firmware revision differs from that stated in the drive’s
configuration file.
4 =
OFF-LINE – Adapter is off-line.
5 =
ON-LINE – Adapter is on-line.
6 =
RESET – Adapter is performing a hardware reset.
5132 \J%*\6! \\\\9/  9/
Contains the revision of the module’s CPI program. Format is xyz where:
• x = major revision number
• y = minor revision number
• z = correction number
/@_ 107 = revision 1.07