Johnson Controls York AYK550 - Overview and Configurations

3 
%**8=); YORK, A Johnson Controls Company
#2@@=,2h\J
&?
The AYK550 can be set up to accept control from an external system using standard
serial communication protocols. When using serial communication, the AYK550 can
either:
• Receive all of its control information from the fieldbus, or
• Be controlled from some combination of fieldbus control and other available
control locations, such as digital or analog inputs, and the control panel.
Two basic serial communications configurations are available:
• EFB (embedded fieldbus) – See "Serial Communication – EFB" on page 140.
• FBA (fieldbus adapter) – With one of the optional FBA modules in the drive’s
expansion slot 2, the drive can communicate to a control system using one of the
following protocols:
– Profibus-DP®
– LonWorks®
– CANopen®
– DeviceNet®
– ControlNet®
– Ethernet®
The AYK550 detects automatically which communication protocol is used by the
plug-in fieldbus adapter. The default settings for each protocol assume that the
profile used is the protocol’s industry-standard drive profile (e.g. PROFIdrive for
PROFIBUS, AC/DC Drive for DeviceNet). All of the FBA protocols can also be
configured for the YORK Drives profile.
Configuration details depend on the protocol and profile used.These details are
provided in a user’s manual supplied with the FBA module.
Fieldbus
Fieldbus Controller
Other Devices
Connect using either:
•
Standard EFB (embedded fieldbus) at
terminals X1:28…32
•
FBA (fieldbus adapter) module mounted
in slot 2 (option Rxxx)