Johnson Controls York AYK550 - Specific Macro Configurations

 
$ YORK, A Johnson Controls Company
4,
This macro provides the factory default parameter settings for the AYK550-UH.
Factory defaults can be restored at any time by setting parameter 9902 to 1. The
diagram below shows typical wiring using this macro. When using direct speed
reference in AUTO mode or process PID, see "General Considerations" on page 30.
2,8 YORK Drives are pre-configured using the “HVAC” default macro. Changing
user macros may require changes to factory control wiring.
%@,973!,,24,
%@, 
%@, 
None (Default macro)
1SCR
2AI1
3AGND
4 10V
5AI2
6AGND
7AO1
8AO2
9AGND
10 24V
11 GND
12 DCOM1
13 DI1
14 DI2
15 DI3
16 DI4
17 DI5
18 DI6
19 RO1C
20 RO1A
21 RO1B
22 RO2C
23 RO2A
24 RO2B
25 RO3C
26 RO3A
27 RO3B
/,4=0(2)…10 V or 0(4)…20 mA
Reference voltage 10 VDC
&,,4<=+_0(4)…20 mA
#,,`#,2_ Activate to start drive
Not configured
2,,%,3 (P 1202)
#4,+,2=W_ Deactivate to stop drive (P 1608)
Not configured
Relay output 1 (P 1401)
Default operation: !3+=>19 connected to 21
Relay output 2 (P 1402)
Default operation: !7 =>22 connected to 24
Relay output 3 (P 1403)
Default operation: \, =>25 connected to 27
m
&,,=,_ 0(4)…20 mA
Not configured
Analog input circuit common
%*43;=W_ 0(2)…10 V or 0(4)…20 mA
Analog output circuit common
Auxiliary voltage output +24 VDC
Common for DI return signals.
Digital input common for all
Signal cable shield (screen)
Analog input circuit common
(Fault => 25 connected to 26)
i
AI1: 0(2)
…10 V
AI2: 0(4)
…20 mA
&
&
Jumper Settings
+
mA
mA
+