Johnson Controls York AYK550 - Page 55

 
$ YORK, A Johnson Controls Company
2_&,7,
This group contains drive operating data, including actual signals. The drive sets the
values for actual signals, based on measurements or calculations. You cannot set
these values.
2_&,7,
23 =,2 !7 !2,2 4, #
0102 #% Q @  @ 
The calculated speed of the motor (rpm).
0103 &'%'\!p >> Z > Z 
The frequency (Hz) applied to the motor. (Also shown by default in OUTPUT display.)
0104 !!' >>d*
F
>  
The motor current, as measured by the AYK550. (Also shown by default in OUTPUT display.)
0105 '&!p FFq >q 
Output torque. Calculated value of torque on motor shaft in % of motor nominal torque.
0106 %&6! >>d%

> W6 
The measured motor power in kW.
0107 J#&"' F>d
3
 
The DC bus voltage in VDC, as measured by the AYK550.
0109 &'%'&"' F>d
3
 
The voltage applied to the motor.
0110 !*'%  q>q
The temperature of the drive heatsink in Centigrade.
0111 m'!"!\ Q @`  @` 
 Z > Z
External reference,
REF1, in rpm or Hz – units determined by parameter 9904.
0112 m'!"!\F q >q 
,2<_^q
External reference,
REF2, in %.
0113 '!""&'*& F  
Active control location. Alternatives are:
0 =
HAND
1 = EXT1
2 =
EXT2
0114 !'*! kkkk9  9 9
The drive’s accumulated running time in hours (h).
• Can be , by pressing UP and DOWN buttons simultaneously when in parameter set mode.
0115 6&'!! kkkkW69  W69 
The drive’s accumulated power consumption in kilowatt hours.
• Can be , by pressing UP and DOWN buttons simultaneously when in parameter set mode.
0116 %%"J"&'%' q >q 
,2<_^q
Application block output signal. Value is from either:
• PFA control, if PFA Control is active, or
• Parameter 0112
EXTERNAL REF 2.