FORM 160.72-O1 (810)
JOHNSON CONTROLS
28
CONDENSER SCREEN
Displays the difference between the Condenser Refrig-
erant Temperature and Subcooled Refrigerant Temper-
ature. If both the Condenser Refrigerant Temperature
and Subcooler Refrigerant Temperature sensors are
present and enabled.
See information above concerning Condenser Refrig-
erant Temperature and Subcooler Refrigerant Tem-
perature.
The service access level is required to enable/disable
these displays
High Pressure Switch (Open / Closed)
Displays the present position of the High Pressure
Switch. This will indicate whether a high pressure fault
is present.
Condenser Liquid Flow Switch (Open / Closed)
Indicates whether flow is present in the condenser.
Condenser Liquid Pump (Run / Off)
Indicates whether Condenser Liquid Pump is operating.
Condenser Flow
Displays the Condenser Water Flow, in GPM, if the
sensor is present.
PROGRAMMABLE
Refrigerant (Enabled / Disabled)
Access Level Required; SERVICE
When a Condenser Refrigerant Temperature Sensor
has been installed it must be enabled via this toggle
before the system will utilize the new, enhanced reso-
lution input. Service Technicians refer to the Service
Instructions (Form 160.72-M1).
NAVIGATION
Home
Access Level Required: VIEW
Returns user to Home Screen.
Refrigerant Level Control
Access Level Required; SERVICE
Moves to the sub-screen allowing programming of the
Refrigerant Level Control setpoints.
To Next Page
Loading...
