JOHNSON CONTROLS
132
FORM 160.54-O1
CUSTOM SETUP SCREEN
OVERVIEW
(Flash memory Card version C.MLM.01.04 or later)
This screen allows the Service technician to select up to
10 parameters for display on the Custom View Screen.
Requires a login access level of SER-
VICE. Service Technicians refer to
YORK Service Manual 160.54-M1
for operation instructions and expla-
nation of all programmable setpoints
and displayed values.
DISPLAY ONLY
Slot Numbers
Lists the available parameters that can be displayed.
The desired parameters for display are selected from
this list.
PROGRAMMABLE
Page Up
Scroll up through list of available parameters.
Page Down
Scroll down through list of available parameters.
Select
First use the Page Up and Page Down keys to scroll
through the Slot Numbers list and note the number of
the parameter(s) to be displayed. Pressing the Select key
places a green colored selection box around Custom Slot
1. If it is desired to change an already entered parameter,
use the 5 and 6 keys to place the selection box around
the slot number to be changed. With the selection box
around the slot number to be changed or entered, press
the ENTER (‘’) key. A dialog box is displayed permit-
ting data entry. Using the numeric keypad keys, enter the
desired slot number and press the ENTER (‘’) key.
Custom Slot (1-10)
Use the Select key and numeric keypad keys as described
above and enter the slot number from Slot Numbers
list. Setting the Slot number to zero clears the display
of this slot number.
NAVIGATION
Home
Access Level Required: VIEW
Causes a return to the Home Screen.
Custom View
Access Level Required: SERVICE
Causes a return to the Custom View Screen.
FIG.39
00325VIP
OptiView Control Center
To Next Page
Loading...
