Trend setup screen
Figure 45: Trend setup screen
The trend setup screen displays chiller trend setup fields. There are no display only fields.
This screen is used to configure the trending screen. Select trending parameters from the Common
slots screen or Master slot numbers list and entered as Slot Numbers for Data Points 1 to 6. The Y-
Axis minimum and maximum values for each parameter are entered as Data Point Min and Data
Point Max for Data Points 1 through 6. The interval at which all the parameters are sampled is
selected as the Data Collection Interval.
Table 99: Programmable fields
Button Access Description
Select Operator
Enter slot numbers and the minimum and maximum Y-axis values of each
parameter to be trended. Pressing this button places a yellow box around
Data Point 1 Slot Number. Use the arrow keys to place the box around the
value of data points 1 to 6 to be changed. With the required value selected,
press Enter (✓). A data entry dialog box appears.
Chart Type Operator Selects Continuous, One Screen, or Triggered.
Data Point Slot # (1-6) Operator
The slot, maximum percentage, and maximum percentage for a data point
that you want to trend. If the slot is set to 0, trending is disabled for that
point. All points can be disabled.
YVAM with OptiView Control Center100
To Next Page
Loading...
