Figure 65: OKIPOS printer
Printer connections
Connect the printer to the Control Center Microboard as follows. Only one printer can be connected
at a time.
Table 151: Okidata OkiPos 441
Microboard Printer Function
J2-4 pin 3 Tx (data to printer)
J2-2 pin 20 DSR (busy signal from printer)
J2-9 pin 7 Gnd
Cabinet Shield
The following hardware is required:
• Cable: #18 AWG stranded 50 ft (15.24 m) maximum length
The following connectors are required:
• Microboard: None. Strip 1/4 in. (6.35 mm) insulation from wire and insert into screw terminal
block.
• Printers: OKI Data - 25 pin plug DB-25P or equivalent; Shell DB-C2-J9 or equivalent.
Setting up the printer
The selected printer must be configured as follows. Refer to the manual provided by the printer
manufacturer.
OKI Data OKIPOS 441
1. With the printer power off, remove the two screws that hold the RS232 Interface Module.
2. Pull the RS232 Interface Module out of the printer.
3. Set DIP switch SW2-2 to OFF to select 19200 BPS. Do not change any other switch settings.
4. Re-install the RS232 Interface Module and two mounting screws.
5. Load paper and install the printer ribbon into the printer.
6. Connect the printer cable to the printer and the microboard.
7. Connect the printer power cable to the printer and plug into a 100 to 240VAC power source.
YVAM with OptiView Control Center168
To Next Page
Loading...
