System screen
Figure 17: System screen
The system screen gives a general overview of common chiller parameters for both shells.
Table 22: Display only fields
Field name Description
Discharge Temperature The temperature of the refrigerant in its gaseous state at discharge of the compressor as it
travels to the condenser
Input % Full Load Amps The percentage of FLA used by the system
Input Current Limit Setpoint The Active Current Limit Setpoint
Outside Ambient Temperature The outside ambient air temperature
Chilled Liquid Temperature -
Entering
The temperature of the liquid as it enters the evaporator
Chilled Liquid Temperature -
Leaving
The temperature of the liquid as it leaves the evaporator
Chilled Liquid Temperature -
Setpoint
The programmed temperature setpoint for leaving chilled liquid, it is the local or remote
value depending on the control source
Discharge Pressure The compressor discharge pressure
Discharge Saturation The saturation temperature of the compressor discharge gas calculated from the
compressor discharge pressure
Condenser Pressure The refrigerant pressure in the condenser
Condenser Saturation
Pressure
The saturation temperature in the condenser calculated from the condenser pressure
Suction Pressure The compressor suction pressure
47YVAM with OptiView Control Center
To Next Page
Loading...
