©2011 Johnson Level & Tool 19
Tips from the Pro’s
Take more than one measurement in critical situations where accuracy
needs to be greater than an estimation measurement. Take 3-4
measurements from the same position to compare consistency of each
reading. Prior to important measurements verify that the instrument is
in proper working order and take sample measurements to of a known
distance to verify accuracy.
To accurately measure from the rear of the instrument, use a scrap
piece of drywall or other flat material. Extend the material off the
corner and butt the LDM up to the material. Then take measurement.
Place a white sheet of paper over the targeted measuring surface if
error message Err02 occurs to improve the return signal.
4533H-English_Manuals 4/1/11 10:49 AM Page 19
To Next Page
Loading...
Need help?
General
