Johnson Limpia - Preparing the Vacuum for Use; Turning On the Appliance; Appliance Maintenance; Dust Filter Cleaning

16
DESCRIPTION
A. Adjustable telescopic tube
B. Motor unit
C. On/Off switch
D. Container release button G
E. Dust filter
G. Dust container
H. Extension flexible tube
J. Floor nozzle
L. Upholstery brush
M. Crevice nozzle with two functions
PREPARING FOR USE
Without the plug connected, in order to
reach the filter holder, press the button (D)
to separate the motor unit (B) from the
dust container (G) place the filter selected.
Use with telescopic tube (A):
Connect it to the appliance from the motor
unit side (B). Using the slider adjust the
length.
Place the selected accessory connecting it
to the appliance from the side of the con-
tainer (G).
Use with flexible tube (H): Connect it to the
appliance from the side of the container
(G) with the accessory selected assembled
on the end of the tube.
When cleaning sofas or surfaces with simi-
lar heights it is easier to use the appliance
without the telescopic tube holding it by its
handle.
TURNING ON
Press the switch (C), the vacuum will start
working.
MAINTENANCE
Always perform with the plug disconnec-
ted from the mains.
Empty the dust container (G) when full.
To do this, press the button (D) separate
the motor unit (B) from the dust container
(G).
Remove the filter from the container and
free the container from the dirt you have
collected.
Filter cleaning
The filters must be cleaned every now and
then or when they are obstructed. The fil-
ters in bad conditions lower the suction
and damage the motor.
Dust filter (E): brush it or blow it with a
compressor. Do not wash it.