1.3 Login
1）Use the registered account or directly use the quick login with an existing account on
one of the available platforms to log in, as shown in the following sequence;
2.Bind Heat Pump Water Heater
2.1 Wi-Fi distribution network - Blink Quickly (recommended):
Step 1: Manually enter the Wi-Fi distribution network mode: press and hold the "Switch"
button and "+" button for 5 seconds to enter the pairing state; the "cloud" icon will blink,
and the icon will always display after the pairing is successful; if the pairing is not
successful or there has been no pairing, after 3 minutes, the icon does not display, then
exit the state of distribution network, and the "cloud" icon stops flashing, and the WIFI
module no longer distribute the network. If you want to distribute the network again, you
need to press and hold the "Switch" button and "+" button 5 Seconds again;
Step 2: Turn on the WIFI function of the mobile phone and connect to the WIFI hotspot.
The WIFI hotspot must be able to connect to the Internet normally, as shown in the figure:
connect to the WIFI hotspot "qW9I";
To Next Page
Loading...
Need help?
General