13
brack- ets (X) to the blades (A), leave the
ridges of the brackets turned downwards
(Fig. 4)
Assemble the blade (A)+bracket (X) set
to the motor unit (C) completely
tightening the 2 screws (Fig. 5)
Repeat the operation on the 4 blades.
(Fig. 6)
Screw in the bulb NOT SUPPLIED on the
bulb socket (F) (Fig. 7)
Position the glass shade (B) inside the
edge of the cup (D) and fasten it with
the 3 screws (B1) by tightening delica-
tely. (Fig. 8)
Insert the hanging section (G) in the
ter- minal cover (H) and pass the 4 wires
(Black-Blue-White-Brown) through the
section (G), out of the appliance (Fig. 9).
Fasten the hanging section (G) to the ap-
pliance unit (C) with the through pin (L)
(Fig. 10) and then insert the safety ring
on the pin.
Fasten the fan connection (M) to the
ceiling (Fig. 11) with sufficiently sized
plugs (NOT SUPPLIED) to support the
weight of the appliance.
Pass the 4 electrical wires through the
slot in the cover (Fig. 12).
Fasten the appliance to the ceiling, ensu-
ring the holes on the edge of the ceiling
connection (M) correspond to the 4 ho-
les of the terminal cover (H) and lock all
in place with the 4 screws.
Electrically connect the appliance (C1)
with the wires (N1) on the electrical unit
(N). Blue wire with Blue, White with White
and Black with Black and Brown with
NOT SUPPLIED).
Fasten the electrical unit to the ceiling.
Fasten the cables (N2) on the unit to the
electrical mains cables.
ATTENTION: this operation must be car-
ried out
with power cut. Ensure you have
cut power before doing this!
A. Blades with different finish on the 2
sides
B. Glass shade
B1. Glass shade fixed screws
C. Motor unit
C1. Appliance power cables
D. Light bulb socket cup
E. Blade fastening compartments
X. Blade holding brackets
F. Bulb socket
G. Hanging section
H. Terminal cover
L. Hanging section fastening pin
M. Ceiling connection
N. Electrical unit
N1. Appliance connection cables
N2. Electrical mains connection cables
P. Antenna
S. Remote control
T. ON/OFF fan
U. ON/OFF light
V1. Slow rotation
V2. Medium rotation
V3. Fast rotation
Y.Button remote sense of rotation
Assembly, installation and electrical con-
nection operations must only be carried
out by SPECIALIST, QUALIFIED STAFF.
Fasten the blade (A) to the bracket (X) by
completely tightening the 3 screws
and the respective nuts (Fig. 1) (Fig. 2).
Repeat the operation for the 4 blades.
ATTENTION: choose the blade finish
that will be seen:
white or wood+cane. (Fig. 3) and as-
sem- ble all in the same direction. (Fig.
3-b) ATTENTION: when assembling the
Z.Rotation sensor selector
hanging
Brown. (TERMINAL BOARD
(TERMINAL BOARD
or inside the cap cover terminals (H).
To Next Page
Loading...
