19
COMPONENTS
A. Air emission
B. “ON / OFF” selector + 2 air speeds
C. 3 temperature selector
D. Intakes
E. Ring for attachment to the wall
F. Deflector
G. Filter holder
H. Filter
Remove the appliance parts from the
package and dispose of the packaging
components according to the law. Check
that the product is intact and that all
components are present. In the event of
obvious anomalies or transport damage,
do not use the appliance, but contact the
retailer or an authorized service center.
INSTRUCTIONS FOR USE
Make sure your hands are completely dry,
after setting the selector (B) to “0” insert
the plug into a suitable electric socket.
How to set speed and temperature
Selector B on “0” and selector C on “0”:
appliance off
Selector B on “I” and selector C on “0”:
medium air flow speed and minimum
temperature for drying slightly damp hair
Selector B on “II” and selector C on “0”:
medium air flow speed and medium
temperature for quick drying of slightly
damp hair
Selector B on “I” and selector C on “I”:
strong air flow speed and minimum tem-
perature for medium hair drying
Selector B on “I” and selector C on “II”:
strong air flow speed and medium tempe-
rature for gentle hair drying
Selector B on “II” and selector C on “I”:
strong air flow speed and medium tempe-
rature for gentle drying of the hair
Selector B on “II” and selector C on “II”:
strong air flow speed and maximum tem-
perature for quick hair drying
Selector B on “0” and selector C on “I”:
strong air flow speed and minimum tem-
perature for medium hair dryingSelettore
Selector B on “0” and selector C on “II”:
strong air flow speed and medium tempe-
rature for gentle hair drying
Proceed to dry the hair. When the hair is
dry, turn the selector (B) and (C) back to
“0” and disconnect the plug from the elec-
trical socket.
RING FOR HANGING
Once you have finished using it, you can
hang the product, thanks to the special
ring for attachment to the wall (E).
USE OF THE DEFLECTOR
The removable deflector (F) directs the air
flow to a precise point. Its use is recom-
mended for drying or modeling localized
areas, so as to make the desired hairstyles
more easily.
To mount this accessory, center it on the
tip of the hairdryer (H) and exert a slight
pressure towards the appliance.
To remove it, exert a slight pull towards
the outside.
N.B .: always wait for the deflector (F) to
cool down before removing it.
SECURITY SYSTEM
The appliance is equipped with an anti-
overheating device. In the event of overhe-
ating, heating is stopped and only cold air
is blown out. After cooling, the heating
automatically switches on again with the
emission of hot air again.
Always make sure that the air intakes (D)
and the air outlet (A) are not obstructed
and keep them clean from dust and hair.
CLEANING
ATTENTION: before any cleaning opera-
tion, turn off the appliance and discon-
nect the plug from the electrical socket.
Cleaning the appliance and accessories
Clean the hairdryer and the deflector (F)
if necessary with a soft, damp cloth. Do
not use solvents or aggressive or abrasive
detergents. Otherwise you risk damaging
the surfaces.
Never immerse the appliance in water or
other liquid substances.
Regularly check the suction sockets of the
appliance and remove dust and accumu-
lated hair.
Cleaning the suction filter
To clean, proceed as follows:
remove the filter holder (G) by turning it
counterclockwise to detach it from the
body of the appliance, then remove the
filter (H) as well.
To Next Page
Loading...
