JOICO STYLER | 17
Instructions:
Filling The Reservoir
Please note: Fill the reservoir only with JOICO K-Pak ReconstRx
VaporFuel.
If you do not want to use the vapor function, leave the tank empty
and turn the fuel control button on the back of the iron to the OFF
position.
Attention: Never remove the reservoir when the
applianceis HOT. Always fill when the appliance is
COLD.
1. Pull back on the reservoir release button and remove
the reservoir from the appliance.
2. Pull back on the rubber reservoir cap and fill the
larger of the two holes with ReconstRx VaporFuel
3. Replace the rubber cap.
4. Snap the reservoir back onto the JOICO Styler. Insert
the wide end of the reservoir first, then press down
on the reservoir until you hear it click into place
How To Use:
1. Plug the appliance into a power socket (220 V).
2. Press the ON-position. The indicator light will show red.
3. Use the temperature control +/- and select your desired
temperature setting. While heating, the green lights will flash.
When the JOICO Styler has reached your selected operating
temperature, the green light will remain lit.
4. Always use a temperature that is appropriate to your hair type.
(See table below).
HAIR TYPE RECOMMENDED TEMPERATURE SETTINGS
Fine/chemically treated hair 150° C
Medium 170° C
Thick 180° C
Very Thick, Coarse 200 - 210° C
5. To turn the appliance off, push the on/off button until the lights
go out.
6. Unplug the appliance and let it cool down before storing.
Cleaning & Care
Storage
If you do not use the appliance for longer than 5 days, please
remove the reservoir and store it separately.
Specifications
Power supply of AC 220-230V, 50/60Hz, 60W.
To Next Page
Loading...
Need help?
General