Need help?Do you have a question about the JONARD TOOLS TBS-100 and is the answer not in the manual?
General| Type | Tone and Probe Kit |
|---|---|
| Tone Frequency | 1 kHz |
| Battery Type | 9V |
| Weight | 0.5 lbs |
| Battery Compatibility | Alkaline |
| Display | LED |
| Tone Amplitude | 8 Vpp |
Link the TBS-100 to the telephone line by clamping the ABN clips directly.
Use the HOOK Button to illuminate the indicator light to make calls, and pick up to receive.
Redial last number via Tone Mode. Hold '*' for 3 sec for Pulse Mode redial.
Press the MUTE Button during conversations to mute your voice.
Hold the '*' Button for 3 seconds to switch between Tone and Pulse modes.
Press the 'PAUSE' button to pause dialing for 3.5 seconds.
Use the Switch Box and Telephone Line Test Cord for testing connections.
Ensure tester is hung up before connecting clips; check fuse if indicator light is dim.
The hook for hanging the device during operation.
Accessory used with the test cord for line connections.
Direct connection clips for telephone line wires.
The primary cable integrated with the butt set for testing.
Cord used in conjunction with the Switch Box for testing.
To Next Page
