16
1
2
Safety equipment
1
Fitting mod. 2095
Replace damaged or worn parts and fit in
the reverse order to dismantling.
Fitting mod. 2095
Replace damaged or worn parts.
Fit in the reverse order to dismantling.
Pay attention to the following:
● The spring’s straight shank should be
fitted in the throttle control lock (1).
● Make sure the throttle wire housing is
well pressed down in the recess (2).
● Check that the short-circuiting cable
sits in the recess so that it is not
clenched when the handle half is
screwed tight.
To Next Page
Loading...