English---19
115304126 Rev. 2 7/15/10
WORKING TECHNIQUES
S Do not allow the trimmer head to con--
stantly come into contact with the ground
during normal cutting. Constant contact
of this type can cause damage and wear
to the trimmer head.
Sweeping
S The fan effect of the rotating line can be
used for quick and easy clearing up.
Hold the trimmer line parallel to and
above the area to be swept and move
the tool to and fro.
S When cutting and sweeping you should
use full throttle to obtain the best results.
W ARNING: Neither the operator
of the machine nor anyone else may
attempt to remove the cut material
while the engine is runni ng or the
trimmer line is rotating, as this can
result in serious injury . Stop the
engine and trimmer head before you
remove material that has wound
around the drive shaft as otherwise
there is a risk of injury . The bevel
gear can get hot during use and may
remain so for a while afterwards. Y ou
could get burned if you touch it.
W ARNING: Watch out for thrown
objects. Always wear eye protection.
Never lean over the cutting attach-
ment guard. Stones, rubbish, etc.
canbethrownupintotheeyes
causing blindness or serious injury.
Keep unauthorized persons at a dis-
tance. Children, animals, onlookers
and helpers should be kept outside
thesafetyzoneof 15metres. Stop
the machine immediately if anyone
approaches.
To Next Page
Loading...
