Jonsered BV 2125C - Operation; Know Your Blower; Throttle Lever; Primer Button

SHOULDER STRAP ADJUSTMENT
1. Hold the unit as shown with the muffler side
facing away from your body and clothes.
2. Pass the shoulder strap over your head
and onto your right shoulder.
3. Exteod your left arm toward the rear of the
vacuum bag.
4. Adjust shoulder strap until the vacuum
bag/shoulder strap seam lies between
your thumb and index finger.
5. Make sure air flows freely from the elbow
tube into bag. If bag is kinked, the unit will
not operate properly.
KNOW YOUR BLOWER
READTHIS INSTRUCTION MANUALAND SAFETY RULESBEFORE OPERATINGYOUR UNIT
Compare the illustrationswith your unit to familiarize yourself with the location of the various controls
and adjustments. Save this manual for future reference.
MULCHING BLADES
Your blower is equipped with mulching blades as a standard feature. When using the optional
vacuum attachment, the mulching blades automatically reduce debris at a ratio of up to 16:1.
Lower
Vacuum Tube
Upper
Vacuum T_
Throttle
Primer Button
Choke Lever
Fuel Mix
Elbow Tube
Blower
Tube
\
Rope
Rear
Handle
THROTTLE LEVER
The THROTTLE LEVER is used to select the
desired engine speed and to stop the engine.
Movethethrottlelevertothe '_ positionfor
full speed operation. Move the throttle lever
tothe _ positionfor idlespeed. To stopthe
engine, move the throttle lever to the STOP
position.
PRIMER BUTTON
The PRIMER BUTTON removes air from the
carburetor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulls on the starter rope. Activate primer button
by pressing itand allowing itto return to itsorigi-
nal position.
-5-
CHOKE LEVER
The CHOKE he_ps to supply fuel to the engine
to aid in cold starting. Activate the choke by
moving the choke lever to the FULL CHOKE
position. After engine attempts to start, move the
choke lever to the HALF CHOKE position.
Once engine starts, move choke lever to the
RUN position.