English – 41
8009-274
Lubricating the front wheel bearings
The front cover and wing covers must be removed
on machines with rear ejection, so that the tubular
loop can be lifted to remove the wheel.
1. Remove the plastic cover that covers the centre
of the wheel.
2. Remove the circlip and washer on the front
wheel axle.
3. Lift off the wheel.
4. Lubricate the stub axle with molybdenum
disulphide grease*.
5. Fit the parts in the reverse order.
IMPORTANT INFORMATION
Check that the circlip enters the groove
correctly.
LUBRICATION
* Grease from well-known brand names (petrol
companies, etc.) usually maintains a good quality.
The most important property is that the grease
provides good protection against corrosion.
To Next Page
Loading...
