Engine fault
Transmission fault
Engine speed falling
Drive belt for transmission shaft
Transmission overheated
Oil level too low
The machine slows down
under heavy loads
The drive belt
The hydrostatic transmission’s
cooling fan
Belt wheel on the hydrostatic
transmission’s ingoing shaft
Hydrostatic transmission
Bypass valve
The valve’s needle wrongly
placed
Check the belt tensioning
device
Belt worn
Fan blades damaged or moving
against foreign objects
The wheel is loose or damaged
Oil level too low
Oil filter blocked
Noise from transmission
Repair the engine
Belt worn or oily
Clean or replace belt
Adjust belt tension
Stop and allow the transmission
to cool. Clean the cooling fins
Fill with engine oil SAE 10W/30
to right level
Repair
Lubricate bearing or replace belt
tensioning device
Replace belt
Clean or replace fan
Fill with engine oil SAE 10W/30
to right level
Tighten or replace belt wheel
Replace oil filter
The hydrostatic transmission must not be opened while under guarantee.
To Next Page
Loading...
