22 – English
Maintenance
6 Fit the belt according to the picture.
7 Tension the belt with the belt adjuster.
8 Fit the front cover.
9 Set the cutting deck height control in any of the positions 1
-5.
Checking the blades
To achieve the best mowing results it is important that the
blades are undamaged and well-sharpened.
Check that the blades’ attachment screws are tight.
• Put the unit in the service position, see Service position
f
or the cutting unit.
The blades should be balanced after shar
pening.
Damaged blades should be replaced when hitting obstacles
that result in a breakdo
wn. Let the ser
vicing dealer judge
whether the blade can be repaired/ground or must be
discarded.
Removing the Mulching plug
To change a Combi deck from the Mulching function to a
cutting deck with rear ejection, remove the Mulching plug,
which is located under the unit, attached with a screws.
1 Put the unit in the service position, see Service position
for the cutting unit.
2 Loosen the scre
w holding the plug and remove it.
3 Fit cutting unit.
IMPORTANT INFORMATION
Replacing or sharpening the blades should be conducted
by an authorised service workshop.
!
WARNING! If the blades are cracked,
whether caused by poor repair or other
damage, they could break while being used.
The risk increases if the blades are poorly
balanced.
To Next Page
Loading...
