English – 25
Maintenance
Fitting the cutting head
1 Position the machine on flat ground. Apply the parking
brake.
2 Check that the lever for setting the cutting height is in the
lowest position and that the lifting lever for the cutting unit
is in mowing position.
3 Push the equipment frame down and place the catch
against the frame.
4 Engage the belt in the belt holder.
5 Push the deck in and put the front guide plugs in the
grooves on the equipment frame, one on each side.
6 Lift up the cutting unit
7 Push the unit in so that the interior plugs touch the bottom
of the equipment frame’s grooves.
8 Fit the drive belt around the drive wheels of the cutting
unit.
9 Make sure the belt is placed on the correct side of the belt
tensioner wheel.
10 Hook up the height adjustment strut.
11 Secure the collet spring.
12 Fit the front cover.
!
WARNING! Wear protective glasses when
fitting the cutting unit. The spring which
tensions up the belt may break and cause
personal injury.
!
WARNING! Observe caution to avoid
trapping your hand.
1
2
To Next Page
Loading...
