13
1 532 17 05-51 Control Th/ch Flag
2 817 72 04-08 Screw Hex Thd Cut 1/4-20 x 1/2
3 532 43 86-18 Engine B&S Model No. 31A507-2391-B1
4 532 18 86-55 Muffler
8 532 17 18-77 Bolt
13 532 16 52-91 Gasket Eng
23 532 16 98-37 Shield Brn/Dbr Guard
25 532 19 06-95 Control Choke
29 532 13 71-80 Kit Spark Arrecter
31 532 40 75-16 Tank Fuel Front
32 532 43 02-20 Cap Fuel
33 532 12 34-87 Clamp Hose Blk
37 532 13 70-40 Line Fuel 20"
40 532 12 40-28 Bushing Snap Nyl Blk Fuel Line
44 817 67 04-12 Screw Hexwsh Thdrol 1/4-20 x 3/4
45 817 00 06-12 Screw Hexwsh Thdrol 3/8-16 x 3/4
46 819 09 14-16 Washer 9/32 x 7/8 x 16 Ga.
72 532 19 23-34 Screw Socket HD 5/16-18 x .75
78 817 06 06-20 Screw 3/8-16 x 1-1/4
81 873 51 04-00 Nut Keps Hex 1/4-20 unc
119 532 19 79-49 Guard Pulley LH
120 532 19 79-48 Guard Pulley RH
121 532 19 66-88 Clip
122 532 42 19-22 Extension Drain Oil
129 532 40 03-28 Guard Pulley Adapter
136 532 13 77-29 Screw 1/4-20 x 5/8
KEY PART
NO. NO. DESCRIPTION
NOTE: All component dimensions given in U.S. inches
1 inch = 25.4 mm
TRACTOR - - MODEL NO. LT2114 (96011029301), PRODUCT NO. 960 11 02-93
ENGINE
24
Engine Power Rating Information
The gross power rating for individual gas engine models is labeled in accordance with SAE (Society of Automotive Engi-
neers) code J1940 (Small Engine Power & Torque Rating Procedure), and rating performance has been obtained and cor-
rected in accordance with SAE J1995 (Revision 2002-05). Torque values are derived at 3060 RPM; horsepower values are
derived at 3600 RPM. Actual gross engine power will be lower and is affected by, among other things, ambient operating
conditions and engine-to-engine variability. Given both the wide array of products on which engines are placed and the va-
riety of environmental issues applicable to operating the equipment, the gas engine will not develop the rated gross power
when used in a given piece of power equipment (actual “on-site” or net power). This difference is due to a variety of factors
including, but not limited to, accessories (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application
limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due to manu-
facturing and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this Series engine.
To Next Page
Loading...
