To Next Page

To Previous Page

ASSEMBLY INSTRUCTIONS

1.Placetableatwithplayingsurfacedown.Whenyou

set the table down, make sure that the space beneath it

is clear of anything that can scratch the surface.

2. Unlock the undercarriage and raise the legs to a verti-

cal position.

3. Lower the T-Leg into position. Apply bolt plate to

junction of T-Leg and undercarriage. Insert bolt before

positioning washer and nut to tighten. Then, tighten

bottom bolt as well.

4. Twist the casters into the bottom of the T-Leg.

5. Re-lock the undercarriage into the storage position and

raise the table onto the wheels. Standing table up may

require two people! Please be careful and read

warning below.

All assembly instructions and all descriptions of bolts and

parts are given from the point of view of someone outside

looking inward.

1. Make sure table is in playing position before installing

the net. To do so, release the safety latch and carefully

lower each table half.

2. Attach one net clamp to the middle edge of where the

table halves meet. Repeat this with other net clamp on

opposite side. Then, slide net post into corresponding

clamp and repeat for the other side. Make sure the white

fabric of the net is on top. Use strings at either end of

the net to tighten the net and attach to base of net post

securely.

NET ASSEMBLY

YOU ARE NOW READY

TO PLAY!

NOTE: The two halves do not connect to one another. They

remain two separate pieces. You will apply the net to the

middle where they meet .

WARNING: End legs (without casters) should be in locked,

storage position so that weight of the table is fully on the

undercarriage (with casters) during set up. Damage may

result if table set up procedure is not executed as specied

in the instructions.

JOOLA Inside User Manual

Questions and Answers: