Joovv Max Quick Start Guide

Joovv Max & Joovv Quad
Quickstart Guide — Wall Setup
If you’d prefer instructional setup
videos, please visit:
www.joovv.com/setup
!
Failure to securely install the anti-tip kit could could result in serious
injury. For comprehensive instructions, please review the product
manual that was included with your Joovv devices.
JV-MKTG-QQSG-04
STEP 1
After assembling your Max or Quad following the step on
the opposite side, attach the included floor bumpers on the
bottom end caps. First adjust the nut to the end of the
thread. Then insert the nut into the slotted hole and slide
forward into position. While pulling down to hold the nut in
position, twist the bumper clockwise to lock it in place, as
shown in Figure A.
STEP 2
Insert two threaded posts into the top end caps using the
far left and far right holes. Then, attach one 90 mm braided
cable to each threaded post. Next connect the anti-tip
bracket to each braided cable, and with a pencil, mark the
spot directly behind the threaded posts, as shown in
Figure B.
STEP 3
Next, remove the braided cables from the threaded post
and reposition your Max or Quad to the side. Place the anti-
tip bracket on the wall with the center aligned with the
pencil marked location. Then mark each hole location with a
pencil. Drill a 7/32’’ hole for each marked hole and insert the
included wall anchors. Use a hammer to tap the anchors
into position, then attach the brackets to the wall using the
included screws, as shown in Figure C.
STEP 4
Place your Max or Quad back into position and plug back in
the power cords and turn back on each device. Then, screw
the braided cables to the threaded posts securing your Max
or Quad and you’re ready to start Joovvin’!
FIG. A
FIG. B
FIG. C

Joovv Max Specifications

General

Brand	Joovv
Model	Max
Category	Personal Care Products
Language	English