Need help?Do you have a question about the joule HEATBANK and is the answer not in the manual?
General| Heating Capacity | Unknown |
|---|---|
| Cooling Capacity | Unknown |
| Energy Efficiency Ratio (EER) | Unknown |
| Coefficient of Performance (COP) | Unknown |
| Refrigerant | Unknown |
| Noise Level | Unknown |
| Weight | Unknown |
| Dimensions (HxWxD) | Unknown |
| Power Supply | Unknown |
| Operating Temperature Range | Unknown |
Comprehensive specifications including output, COP, energy consumption, and operating parameters.
Safety instructions for installation, including location, clearances, and connections.
Warnings about scalding from hot water and the need for tempering valves.
Safety protocols for authorized service personnel and maintenance procedures.
Adherence to EN 60335-1 for electrical appliance safety.
Details safety devices like pressure switches, safety cut-outs, and temperature sensors.
Explains the role of the high pressure switch in appliance protection.
Describes the high limit safety cut-out for preventing over-temperature.
Emphasizes that installation must be performed by certified personnel only.
Guidelines for choosing a suitable, dry, frost-free room with proper ventilation.
Instructions for lifting, positioning, and aligning the appliance, including feet adjustment.
Instructions for connecting the condensate hose to the drain and collection area.
Guidance on connecting air inlet/outlet ducts, including length limits and insulation.
Step-by-step instructions for filling the cylinder with water and bleeding air.
Specifies water quality parameters (hardness, chloride, etc.) for appliance longevity.
Details on operational features, display indicators, and functions.
Defines 'auto' and 'man' symbols indicating programmed or continuous operation.
Instructions on how to set and confirm the desired domestic hot water temperature.
Procedure for calling up and navigating the appliance's main menu options.
Access to settings like date, operating times, legionella, fan, ducts, and defaults.
Guide to configuring temperature units, date, time, and day of the week.
Instructions for setting operational periods for the heat pump in 'Prog' submenu.
Instructions for programming user-defined operating times for P2 and P3 modes.
Step-by-step guide for setting start and end times for operating periods.
Explains the 'Leg' function for killing bacteria and its weekly requirement.
Explanation of the fault diagnosis system, including fault codes and symbols.
Instructions on how to reset the fault display after resolving issues.
Table listing all fault codes, their descriptions, and corresponding remedies.
Warning about electrical hazards and the need to isolate power before work.
Procedures for regular checks of faults, cleanliness, and connections.
Requirement for certified contractors to perform work on the refrigerant circuit.
To Next Page
