www.joy-it.net
Pascalstr. 8 47506 Neukirchen-Vluyn
Now you can plug the Battery-HAT onto the StromPi.
Next, plug the supplied circuit board onto the first pins of the Battery-
HAT and connect the cables previously soldered to the StromPi to the lo-
wer two pins on the le side of the board. It does not matter which cable
is plugged to which pin.
If you use the smaller 1000mAh Battery-HAT, you have to stick the supp-
lied foam spacer on the board from below.
To Next Page
Loading...
